Zanussi TH 500, Instruction Booklet

Page: 13 / 20

13
Insert the ducting spigot into the aperture on the top of
the cooker hood casing.
Fitting the Wall Cabinet
If it is necessary to fix the kitchen cabinet to a hollow
construction plaster or partition board structure then it
must be sufficiently reinforced to be strong enough to
support the weight of the cooker hood.
Wall Cabinet Preparation
Position the cooker hood upside down, ensuring the
cooker hood is supported. Open the visor and remove
the two metal grease filter cassettes (see maintenance
and cleaning section).
Mark the position for the cut-out for the cooker hood on
the underside of the kitchen cabinet. The cut-out should
measure, lenght 503 mm by depth 162 mm.
Mark the position for the cut-out for the ducting on the
top of the kitchen cabinet ensuring that the centre of the
hole aligns with the centre of the ducting spigot.
A pad saw or similar cutter will be required to cut the
rectangular hole for the cooker hood and the circular
hole for the ducting spigot.
Before inserting the cooker hood inside the cabinet
ensure a hole has been provided to route the mains
cable.
Securing the cooker hood to the wall
cabinet
1. Insert the upper casing of the cooker hood
through the hole from the underside of the cabinet
ensuring that the butterfly bracket screws have
been loosened sufficiently to allow the wings to
be folded back.
2. Tighten the butterfly bracket screws, by rotating
the screws clockwise.
3. If further alignment of the cooker hood is required
the lower section of the casing can be adjusted
horizontally, backwards and forwards.