Zanussi ERC07002W8, User Manual

Page: 6 / 12

Rear spacers
In the bag with the docu-
mentation, there are two
spacers which must be fit-
ted as shown in the figure.
Using fine strokes of ham-
mer put them in their
place.
Location
The appliance should be installed well away from sour-
ces of heat such as radiators, boilers, direct sunlight
etc. Ensure that air can circulate freely around the back
of the cabinet. To ensure best performance, if the appli-
ance is positioned below an overhanging wall unit, the
minimum distance between the top of the cabinet and
the wall unit must be at least 100 mm .
Ideally, however, the appliance should not be posi-
tioned below overhanging wall units. Accurate levelling
is ensured by one or more adjustable feet at the base of
the cabinet.
If the cabinet is placed in a corner and the side with the
hinges facing the wall, the distance between the wall
and the cabinet must be at least 10 mm to allow the
door to open enough so that the shelves can be removed.
Warning! It must be possible to disconnect the ap-
pliance from the mains power supply; the plug
must therefore be easily accessible after installation.
~10 cm
A B
~2,5 cm ~2,5 cm
Door reversibility
Important! To carry out the following operations, we
suggest that this be made with another person that will
keep a firm hold on the doors of the appliance during
the operations.
To change the opening direction of the door, do these
steps:
6