Zanussi ERC07002W8, User Manual

Page: 4 / 12

Operation
Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise to a medium
setting.
The Temperature Regulator is situated on the side of the
cabinet.
Switching off
To turn off the appliance, turn the Temperature regulator
to the "O" position.
Temperature regulation
The temperature is automatically regulated.
To operate the appliance, proceed as follows:
• turn the Temperature regulator toward lower settings
to obtain the minimum coldness.
• turn the Temperature regulator toward higher set-
tings to obtain the maximum coldness.
In the ice-making compartment -2 ºC or lower tem-
perature can be reached if the Temperature regula-
tor is set according to following table:
Ambient temperature Temperature regulator
setting
+10... +16 ºC "1"
+16... +25 ºC "1-2"
+25... +32 ºC "2-3"
+32... +38 ºC "3-4"
Daily use
Using of the ice-maker compartment
This appliance is equipped with an ice-maker compart-
ment.
In the ice-maker compartment can be reached -2 °C or
lower temperature depending on setting of thermostat
control.
This compartment is suitable for making and storing ice-
cubes. (You can purchase the needed ice-cube tray
from a specialist shop.)
Important! Do not use metallic instruments to remove
the ice-cube tray from the freezer.
Care and Cleaning
Caution! Unplug the appliance before carrying
out any maintenance operation.
This appliance contains hydrocarbons in its cool-
ing unit; maintenance and recharging must there-
fore only be carried out by authorized technicians.
Many proprietary kitchen surface cleaners contain chem-
icals that can attack/damage the plastics used in this ap-
pliance. For this reason it is recommended that the out-
er casing of this appliance is only cleaned with warm wa-
ter with a little washing-up liquid added.
After cleaning, reconnect the equipment to the mains
supply.
Defrosting of the ice-maker compartment
A certain amount of frost will always form around
the ice-maker compartment.
Important! Defrost the ice-maker compartment when
the frost layer reaches a thickness of about 3-5 mm.
To remove the frost, do these steps:
1. Turn the Temperature regulator to the "0" setting
and disconnect the mains plug from the mains socket.
2. Empty the ice box.
3. Leave the door of the appliance and ice-maker com-
partment open.
4. Defrosting usually takes several hours. When finish-
ed, pour defrost water gathered out of the tray and
wipe the surfaces dry.
5. Insert the plug into the wall socket and turn the ther-
mostat control to a medium setting.
4