13
Melting water flows through defrost water outlet
leaded through the back into the evaporator tray
maintained on the top of compressor and evaporates
due to its warmth.
Check and clean the outlet of melting water
coming during defrosting regularly - a label
inside the appliance warns you for this. If it is
clogged the melting water gathered can cause
earlier failure as it can go to the insulating of the
appliance.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe
scraper has to be stored in the outlet.
The most typical case of clogging up in the melting
water outlet when you put food wrapped in some
paper into the appliance and this paper contacts back
plate of the refrigerator and freezes to it. If you remove
the food right at this moment the paper will tear and it
can cause clogging up in the outlet by getting into it.
So you are asked to be careful - because of the above
- when placing foods wrapped in paper into the
appliance.
In case of increased demand e. g. during
heatwawes, the refrigerator temporarily happens
to operate constantly - during this the automatic
defrosting does not work.
Remaining small ice and frost stains on back plate of
the refrigerator after defrosting period is not abnormal.
Defrosting of the freezer is automatic in this model.
Important
A temperature rise of the frozen food packs during
defrosting may shorten their safe storage life.
Never use sharp metal tools to scrape off frost from
the evaporator as this could damage the appliance
beyond repair.
)
To Change the Light Bulb
Should the light fail to work you can change it as
below:
Break the circuit of the appliance.
Press the rear hook (1) and at the same time slide the
cover in the direction indicated by the arrow (2). So
the bulb can be replaced. (Bulb type: T 25 230-240
V, 25 W, E 14 thread)
After changing the bulb replace the cover, snap it in
place and apply voltage to the appliance.
