Zanotti GS Series, Use And Maintenance Instructions

Page: 20 / 84

20
3 Description of the unit
The GS series includes air-cooled or water-cooled (optional) condensing units built in split version. They
consist of:
4 Operation
1. a condensing unit placed outside the cold room;
2. an evaporator installed inside the cold room;
3. an electric control panel placed on the condensing unit, complete with
wall-mounted remote control panel;
4. two tubes (pre-charged with refrigerant) to be connected to the
corresponding fittings placed on the evaporating and condensing units.
GS single blocks are compression units where cold is produced by vaporizing a liquid refrigerant (HFC
type) at low pressure in a heat exchanger (evaporator). The resulting vapour is brought again into the liquid
state by mechanical compression at a higher pressure, followed by cooling in another heat exchanger
(condenser).
The compressor is hermetic, with reciprocating motion, supplied with single-phase or three-phase power.
Defrost takes place automatically in pre-set cycles, by means of heaters; manual defrost is also possible.
5
Handling
The unit can be handled by lifting and transport means.
UNSCREW THE FIXING SCREWS TO REMOVE CRATING FROM THE UNIT.
(fig. A).
WARNING
Make sure that no one is in transit in the operating area of the lifting/ transport means
to prevent any possible accidents to people.
If the unit is in a w ooden case or crate, sling the packing properly before handling it.
Lifting speed shall be such as not to make the packed unit oscillate dangerously and
possibly fall.
Fig. A