To remove the dirt:
1. –
Remove immediately:
melted plastic, plastic
foil, and food with sugar. If not, the dirt can
cause damage to the appliance. Use a special
scraper for the glass . Put the scraper on the
glass surface at an acute angle and move the
blade on the surface .
–
Remove after the appliance is sufficiently
cool:
limescale rings , water rings, fat stains,
shiny metallic discolorations. Use a special
cleaning agent for glass ceramic or stainless
steel.
2. Clean the appliance with a moist cloth and some
detergent.
3. At the end
rub the appliance dry with a clean
cloth.
Troubleshooting
Problem
Possible cause
Remedy
You cannot activate the appliance
or operate it.
The appliance is not connected to
an electrical supply or it is connec-
ted incorrectly.
Check if the appliance is correctly
connected to the electrical supply
(refer to connection diagram).
Activate the appliance again and set
the heat setting in less than 10 sec-
onds.
You touched 2 or more sensor
fields at the same time.
Touch only one sensor field.
There is water or fat stains on the
control panel.
Clean the control panel.
An acoustic signal sounds and the
appliance deactivates.
An acoustic signal sounds when
the appliance is deactivated.
You put something on one or more
sensor fields.
Remove the object from the sensor
fields.
The appliance deactivates.
You put something on the sensor
field .
Remove the object from the sensor
field.
The residual heat indicator does
not come on.
The cooking zone is not hot be-
cause it operated only for a short
time.
If the cooking zone operated suffi-
ciently long to be hot, speak to the
service centre.
The Automatic Heat Up function
does not operate.
The cooking zone is hot.
Let the cooking zone become suffi-
ciently cool.
The highest heat setting is set.
The highest heat setting has the
same power as the Automatic Heat
Up function.
You decreased the heat setting
from .
Start from and only increase the
heat setting.
You cannot activate the outer ring.
Activate the inner ring first.
The sensor fields become hot.
The cookware is too large or you
put it too near to the controls.
Put large cookware on the rear
cooking zones if necessary.
21
Summary of Contents for KEE8447XXK
Page 11: ...Montage min 50mm min 500mm 490 1 mm 750 1mm R 5mm 55mm min 12 mm min 20 mm 11...
Page 23: ...Assembly min 50mm min 500mm 490 1 mm 750 1mm R 5mm 55mm min 12 mm min 20 mm 23...
Page 36: ...Montage min 50mm min 500mm 490 1 mm 750 1mm R 5mm 55mm min 12 mm min 20 mm 36...
Page 49: ...Montage min 50mm min 500mm 490 1 mm 750 1mm R 5mm 55mm min 12 mm min 20 mm 49...
