OPERATION
Cooperation with the transmitters of the EXTA FREE system (example of P-257/2)
• Press short push-button 1 – switching on/ switching off.
• Press push-button 1 for a longer time (>3 s) – brightening/dimming in following sequence:
brighten – stop – dim. The function is available also in the FLOATING mode.
• Press short push-button 2 – selection 1 out of 10 colours from the default setting (see the
table).
• Press push-button 2 for a longer time (>3 s) – entry to the FLOATING mode.
• Press short push-button 2 in the FLOATING mode – change of the step (1-10) for the FLOAT-
ING mode.
• Each change of the step is signalized by a flashing of the load connected to the controller
output. The transition between step 1 and 10 is signalized by repeated flashing of the load.
The step 1 means that the colour change is the fastest (the whole cycle takes about 2 min-
utes), the step 10 means that the colour change is the slowest (the whole cycle takes about
50 minutes).
• Press push-button 2 for a longer time (>3 s) in the FLOATING mode – exit of this mode.
• The controller remembers the last setting of the mode and setting of the level of the lumi-
nous flux intensity after switching off by means of push-button 1.
Cooperation with the P-260 remote control
Switching on a suitable function/programme is carried out by pressing suitable push-but-
tons of the P-260 remote control:
• ON/OFF - switching on/ switching off.
• Brightening/dimming function – pressing this push-button, the function carries out the
fluent change of the luminous flux intensity. This function is available in FLOATING and
STROBE modes.
• FLOATING – activation/deactivation of the programme for automatic and fluent colour
change.
• STROBE – activation/deactivation of the programme for automatic and step by step colour
change.
• TOUCH AREA – allows the colour selection in a fluent way.
If the active mode is the FLOATING or STROBE mode then the following pressing of the push-
buttons described as FLOATING, STROBE carries out the speed change (from 1 to 10 step) in
this mode. Each change of the step is signalized by flashing of the load which is connected
to the controller’s output. The transition between step 10 and 1 is signalized by a repeated
flashing of the load. The step 1 means that the colour change is the fastest (the whole cycle
takes about 120 s), step 10 means that the colour change is the slowest (the whole cycle
takes about 50 minutes).
Colour table defined in the controller
Brightening
ON/OFF
FLOATING mode
STROBE mode
Dimming
Touch field
Fluent colour selection
Button 1 and 2
