The application shows the method to use the LEDIX series fittings with RGB radio controller
and RGB SLR-11 wireless controller. The fittings cooperate with the P-256/8 remote control.
From the remote control level it is possible to switch on/switch off 1 of 8 colours added
to 1÷8 keys or it can be possible to activate the fluent mode (FLOATING) or step by step
mode (STROBE) for the colour change. Depending on the version the fitting can be sup-
plied directly with 230 V AC or with 14 V DC power supply. SLR-11 controller is connected
with RGB tape supplied with 12 V DC. The controller cooperates with a RNK-04 push-button
transmitter. By means of this transmitter the RGB strips can be switched on/switched off or
brightened/dimmed or the FLOATING mode can be released. The controller is designed for
mounting in a typical junction box Ø=60 mm.
APPLICATION
OPERATION TABLE
Symb
ol
RNK
-02
RNK
-04
P-256/8
P-257/2
P-257/4
RNM
-10
RNP
-01
RNP
-02
RNL
-01
RTN-01
RCR-01
RTI-01
RXM
-01
P-260
SLR-11
180 180 230 180 180 230 160 160
-
200
-
160 230 200
CAUTION: The given range concerns open area - an ideal condition without any natural
or artificial obstacles. If there are some obstacles between a transmitter and a receiver,
it is advisable to decrease the range according to: bricks: from 10 to 40 %, wood and
plaster: from 5 to 20 %, reinforced concrete: from 40 to 80 %, metal: from 90 to 100%,
glass: from 10 to 20 %. Over- and underground medium and high electrical power
lines, radio and television transmitters, GSM transmitters set close to a device system
have also a negative influence on the range.
TRANSMITTERS PROGRAMMING
RADIO TRANSMITTERS DELETION
Wireless EXTA FREE system transmitters
Touch P-260 remote control
An exemplary programming procedure with the use of P-257/2 remote control. The
procedure for the rest of radio EXTA FREE transmitters is analogous.
CAUTION: 32 different transmitters can be added to a single SLR-11 controller. In case of
adding more than 32 transmitters, STATUS diode will flash a few times while adding them.
Press and release the first
transmitter’s push-button.
LED red diode switches on
(first the signal pulsates,
next the signal
is constant).
Press and release the
second transmitter’s
push-button. LED red
diode switches on (the
signal pulsates) and
next it switches off - THE
TRANSMITTER IS ADDED.
Press PROG push-button of
SLR-11 device for a longer time
until LED red diode switches on
(constant signal). Next release
PROG push-button.
Press PROG push-button
in SLR-11 controller
for a longer time.
After 5 seconds LED red
diode switches on (the
signal pulsates) and then
it switches off.
Release the push-button
in SLR-11 – THE MEMORY
IS DELETED.
Press PROG push-button in
the controller for a longer
time until STATUS red diode
switches on (constant signal).
Next release PROG push-
button.
Press the switch on/switch
off push-button of the
P-260 remote control for
a longer time. STATUS
red diode switches on in
the controller (first signal
pulsates, next the signal
is constant).
Release switch on/switch
off push-button of the
P-260 remote control.
STATUS red diode switches
on (the signal pulsates),
next it switches off - it
means the TRANSMITTER
IS ADDED.
