RADIO TRANSMITTERS PROGRAMMING
BISTABLE mode (for a selected channel):
SWITCH ON/SWITCH OFF mode (two push-buttons for a selected channel):
TIME mode (one push-button for a selected channel):
An exemplary programming procedure with the use of P-257/2 remote control. The
procedure for the rest of radio EXTA FREE transmitters is analogous. CAUTION: Every
transmitter can cooperate with ROP-04 in a different mode, depending on how they
were added to the device. One transmitter can be added during one programming
cycle. Full memory is signalled with pulsating LED red diode.
In order to facilitate the radio transmitters’ programming, every time when we enter the
programming mode of a selected channel (or time adjustment in time mode) the load
connected to that channel is switched on. The channel switch on is connected with LED red
diode lighting (the signal is constant).
Transmitters and time programming is done in a sequence:
Press the transmitter’s
push-button for a longer
time. LED red diode
switches on (first signal
pulsates, next the signal is
constant)
Press and release
transmitter’s push-button.
LED red diode switches on
(first the signal pulsates,
next the signal is constant)
Press and release the first
transmitter’s push-button.
LED red diode switches on
(first the signal pulsates,
next the signal is constant)
Press and release the same
transmitter’s push-button.
LED red diode switches on
(the signal pulsates) and
next it switches off - THE
TRANSMITTER IS ADDED
Press and release the same
transmitter’s push-button.
LED red diode switches on
(the signal pulsates) and
next it switches off - THE
TRANSMITTER IS ADDED
Press and release the
second transmitter’s
push-button. LED red
diode switches on (the
signal pulsates) and
next it switches off - THE
TRANSMITTER IS ADDED
Press PROG push-button of
ROP-04 device for a longer time
until LED red diode switches on
(constant signal). Next release
PROG push-button
Press PROG push-button of
ROP-04 device for a longer time
until LED red diode switches on
(constant signal). Next release
PROG push-button
Press PROG push-button of
ROP-04 device for a longer time
until LED red diode switches on
(constant signal). Next release
PROG push-button
Press the
transmitter’s
push-button
for a longer
time.
Release the
transmitter’s
push-button. LED
red diode switches
on (first the signal
pulsates, next the
signal is constant).
Press the same transmit-
ter’s push-button and
release it. LED red
diode switches on (the
signal pulsates) and
next it switches off - THE
TRANSMITTER IS ADDED.
Press PROG push-button
of ROP-04 device for
a longer time until LED
red diode switches on
(constant signal). Next
release PROG push-
button
MONOSTABLE mode (for a selected channel):
Transmitters’
programming
for channel 1
Press PROG
push-button
of ROP-04 device
Time
programming
for channel 1
Transmitters’
programming
for channel 2
Time
programming
for channel 2
Transmitters’
programming
for channel 3
Time
programming
for channel 3
RADIO TRANSMITTERS DELETION
Press PROG push-button
of ROP-04 device for
a longer time.
After 5 seconds LED red
diode switches on (the
signal pulsates) and then it
switches off.
Release the push-button
in ROP-04 - MEMORY IS
DELETED.
Wait for about
5 sec.
Wait for
about 5 sec.
Wait for about
5 sec.
Wait for about
5 sec.
Wait for about
5 sec.
