22
En
g
lis
h
9. Ins
tall
a
t
io
n Gui
d
e
TNN 300
3) Installing the Rear-mount Thermal Blocks
※
※
Note
▶
Motherboards, that have a Northbridge chipset with integrated video capability and/or a
fan, are not recommended. If such Northbridge is used, the Rear-mount Thermal Blocks
MUST be installed.
▶
During installation, if there is interference with
other components or the FETs near the CPU
are located in region B, the RTB1’s cannot be
installed. I n t h i s c a s e , s t o p i n s t a l l i n g a n d
r e p l a c e t h e motherboard with one that is
recommended.
(www.zalman.co.kr/product/TNN300.html)
▶
To prevent short circuiting the motherboard, the
Rear-mount Thermal Blocks must be installed on flat surfaces without bare wires or solder points.
▶
Thermal pads lose adhesiveness once used, so do not touch the pad’s surface with hands.
①
Clean the surface of the points (rear side of the FET and the Northbridge chipset) where the
RTB1s will be attached.
②
Peel off the Film from the Thermal Pad on both ends of the block and stick the block on the
determined location.
Northbridge
Chipset Area
M/B
Film
Thermal Pad
Rea-Mount
Thermal Block
CPU Area
FET Area
