15
English
RESERATOR 1 V2
※
The specifications of any product may change without prior notice to improve performance.
5) Take out the Power Cable
Pull the Water Pump power cable out
through the Cable Hole.
6) Remove the Cable Fitting
Take the Cable Fitting out of the hole as
shown in the diagram by using a screwdriver
or an awl.
7) Remove the Integrated Water Pump
Pull the Water Pump off the Sink Base
as shown in the diagram.
8) Put on the Sealing Bolt B
After removing the Cable Fitting, screw
on the Sealing Bolt B. Fasten tightly.
If this is not done properly, it may cause
leakage.
9) Reassemble the Sink Base
After all the steps are taken, reattach
the Sink Base to the main body firmly.
Take proper care in doing this as
leakage may result if not done correctly.
Sealing Bolt A
Water Pump
Power Cable
Cable Hole
Cable Fitting
Water Pump
Cable Fiting
Sealing Bolt B
Summary of Contents for RESERATOR1 V2
Page 18: ......
