!8!
ADDITIONAL FEATURES
Auxiliary Setup
If your serial number is lower than 200:
The 3 auxiliary wires supply momentary 5v when pressed. These can be
used to power a small 5v device (i.e. aftermarket alarm functions). To use
these with 12v devices (i.e. air valve or air horn) a 5v triggered relay is
required for each auxiliary function. The TouchBox Auxiliary Relay, a 12v
relay board with 5v triggers, is available to purchase separately. It includes 3,
5v triggered relays with an attached wire harness for easy connection
If your serial number is higher than 200:
The 3 auxiliary wires supply momentary 12v when pressed. These can be
used to power a small 12v device (under 2 amps) like an air horn, electric
tank drain, or trunk popper.
Pressure Display with DigiGauge
The small 3-pin plug on the wiring harness is
an expansion slot for DigiGauge. This will
allow TouchBox to receive pressure readings
and display them on your iPhone. Your
TouchBox device already is set up to send
and receive pressure readings when
connected to DigiGauge.
Positional Faceplate
The faceplate of the TouchBox device is a
perfect square. It is designed so that you can
change the direction of the logo to suit your
trunk layout. Just remove the 4 screws and
rotate it to any direction you desire.
Note:
Do not tamper with the electronics
when the cover is off. It may damage your
device.
