3!
INSTALLATION
Note:
If you have purchesed the plug and play AccuAir VU4 harness,
plug it in inline with your VU4 and continue to step 3. You won’t be using
the main wiring harness or T-Tap connectors that are included in the box.
Step 1:
1)
Attach the included T-Tap connectors to all 8 of your 12v valve wires.
2)
Line up the wire in the metal groove of the clip and use pliers to clamp it
down.
Note:
Squeeze connector hard with pliers until you hear it click.
Step 2:
1)
Reference the wiring diagram on page 1 to connect the TouchBox valve
control wires.
2)
Plug each of the 8 TouchBox valve control wires to its corresponding T-
Tap connector on your valves.
Note:
Ensure that the red spade connector is fully inserted straight into the
blue T-Tap connector.
Step 3:
1)
Install the supplied wireless antenna in
a visible area from outside the car.
Preferably high up in the front or rear
window of the vehicle.
2)
Connect the antenna wire to the
antenna port on the side of the
TouchBox device.
Note:
Ensure that the antenna is screwed
in tight and the wire isn’t kinked or
squished when routed.
