59
CONFIDENTIAL
DOC-USR-0239-04
____________________________________________________________________________________
Z3 Technology, LLC
♦
100 N. 8th St. STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
TS Lowlat Mode
*
(UDP/TSRTP Only)
False
True
Selecting “True” causes the TS muxer
to instead
send packets out as soon as it receives them rather
than buffering them. This results in lower latency
at the expense of decreased network efficiency
and a less smooth bitstream. There is a limit of
5Mbps for TS Lowlat Mode.
Cannot be used with Auxiliary TS File.
Authentication (RTMP
Only)
Disable
Enable
If authentication is required within the Wowza
streaming server, select “Enable” to enter user
credentials.
User (RTMP Only)
Enter a valid Wowza user name.
Password (RTMP Only)
Enter a valid Wowza password.
Dest Address
(ZIXI Only)
Sets destination of Zixi Feeder
TM
stream.
Should be formatted as: “address:port/streamid”
Zixi Auth Enable
(ZIXI Only)
True
False
Selecting “True” allows for entering valid Zixi user
credentials.
User ID (ZIXI Only)
Allows for entering valid Zixi user ID.
Zixi Overhead
(ZIXI Only)
1-100
Adjust Zixi percent overhead.
KLV Enable
True
False
Enables the capture and insertion of KLV data into
the bitstream.
KLV Pid
0-8191 (
35
)
PID assigned to the KLV stream in the TS stream
KLV Bitrate
100
–
1M
Expected bit rate of the KLV stream.
KLV Mode
SDI
FILE
Sets the source type for the KLV stream currently
only and SDI source or a binary file containing KLV
data are the only valid sources.
KLV Source
/dev/gv7601.0
Location of KLV source this will be a character
device for SDI Mode and or a file for FILE Mode.
Channel Controls
Stop Button
Stop current encode session for Channel 1. Encode
must be stopped in order for settings to be
altered.
Start Button
Start encode session for Channel 1.
Delete Button
Removes channel instance for encoding.
status
!Not running, IDLE,
STOPPED, RUNNING,
POLLING
Current status of the encode process.
IDLE
indicates no valid input data is present.
STOPPED
indicates that the unit is not currently
encoding. Must be in this mode to make any
configuration changes.
