Page 9
5.2 Web Server - Encoder
Note: If you use unicast on the encoder, you must also use unicast on the VLC receiver. If you
use multicast on the encoder, you must also use multicast on the VLC receiver.
1. Power on the Z3-MVE-20
2. Wait one minute or until LED #1 on the unit lights up
3. Connect the Ethernet cable from the Z3-MVE-20 unit directly to the PC
4. Disable all wireless and local area connections
5. For a client PC to access the Z3-MVE-20 factory default settings, set the IP address of the
PC to 192.168.x.XX
6. Open Firefox or Internet Explorer 8 (or above) as your web browser
7. Type the
IP address of the Z3-MVE-20
in your web browser (http://192.168.XX.XX) and
the Z3-MVE-20 Encoder web configuration menu will appear
8. Configure the Z3-MVE-20 with your desired settings (See 5.3 Encoder Configuration
Options)
9.
Press “Start Encoder” on the Encoder Control menu
Microsoft Windows users
1. Go to the Start Menu and select
Control Panel
2. Click on Network and Sharing Center
3. Click on View Status
4. Click on Properties.
5. Click Internet Protocol (TCP/IP) and
click Properties.
6. In the Internet Protocol (TCP/IP)
Properties window, select "Use the
following IP address" if not already
selected and specify the IP address
you wish to use. While entering this
data you'll also need to specify the
subnet mask and default gateway.
Linux users
The below information is for how to specify
and adjust your network settings through the
command prompt.
Changing your network
settings will require root access.
1. Get to the command prompt.
2. Move to the /etc/sysconfig/network
directory.
3. Edit the interfaces file and adjust your
network settings in this file.
