Page 17
The web page will respond with:
Status: Changed rate
The video stream will continue uninterrupted with the new parameter.
9.0 UPDATING FIRMWARE
9.1
WEB PAGE
-
Locate the UPD-z3-mve02-v1.04.00.img file on your Z3 Server user account
-
Save the file on your PC where it can easily be found
-
Follow steps 1 through 7 in section
Error! Reference source not found.
-
On the web menu, next to “Firmware Version 1.0.4”, hit the Update button
-
Hit Browse to find the saved .img file on your PC
-
Hit Upload & Update
-
Power off unit
-
Power cycle system for clean boot and system should be updated.
9.2
SD CARD
-
Locate the UPD-z3-mve02-v1.04.00.img file on your Z3 Server user account
-
Place SD card into computer
-
Open the zwriter.exe windows program (provided by Z3)
-
Select the UPD-z3-mve02-v1.04.00.img file
-
Select correct location for your SD card Do NOT make mistake on this item. This will cause wherever
you are writing to be overwritten.
There is no recovery once you hit “Write Device”
-
Eject SD card from computer
-
Place in SD card socket of APP board
-
Power on system with terminal output connected to PC
-
You will see the system updating the flash
-
Once complete, the system will boot.
-
Power off unit
-
Remove SD card
-
Power cycle system for clean boot and system should be updated.
10.0 TROUBLESHOOTING
No video is usually caused by networking issues.
o
First: check IP address and Netmask. Ping PC from Z3-MVE-02 and ping Z3-MVE-02 from PC. Use
direct connection from Z3-MVE-02 to PC without router/customer network. Once video connection
is established, then add in customer specific network equipment.
o
Second: check to make sure firewalls are turned off
o
Third: check video source. Verify video source is outputting compatible analog video
o
Fourth: verify PC is fast enough and has enough DDR to decode compressed video
o
Fifth: verify VLC version is 1.1x or later
