CONFIDENTIAL
Z3-DM816X-PCI2-RPS V2.00.00
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
34
ata1: SATA max UDMA/133 mmio [mem 0x4a140000-0x4a150fff] port 0x100 irq 16
ata2: SATA max UDMA/133 mmio [mem 0x4a140000-0x4a150fff] port 0x180 irq 16 omap2-nand
driver initializing
omap2 driver probed
NAND device: Maf ID: 0xec, Chip ID: 0xd3 (Samsung, )
erasesize: 0x20000, writesize: 2048, oobsize: 64 Scanning device for bad blocks Bad
eraseblock 952 at 0x000007700000 Bad eraseblock 5263 at 0x0000291e0000 Bad eraseblock
6719 at 0x0000347e0000 Bad eraseblock 6978 at 0x000036840000 Bad eraseblock 7029 at
0x000036ea0000 Creating 7 MTD partitions on "omap2-nand.0":
0x000000000000-0x000000120000 : "U-Boot"
hub 1-0:1.0: over-current change on port 1 0x000000120000-0x000000240000 : "U-Boot
Update"
0x000000240000-0x000000260000 : "U-Boot Env Update"
0x000000260000-0x000000280000 : "U-Boot Env"
0x000000280000-0x0000006c0000 : "Kernel"
0x0000006c0000-0x00000cee0000 : "File System"
0x00000cee0000-0x000040000000 : "Reserved"
NAND: size is 1024
davinci_mdio davinci_mdio.0: davinci mdio revision 1.6 davinci_mdio davinci_mdio.0:
detected phy mask fffffffc
davinci_mdio.0: probed
davinci_mdio davinci_mdio.0: phy[0]: device 0:00, driver unknown davinci_mdio
davinci_mdio.0: phy[1]: device 0:01, driver unknown
usbcore: registered new interface driver cdc_ether
usbcore: registered new interface driver dm9601 Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage USB Mass Storage support
registered.
mice: PS/2 mouse device common for all mice omap_rtc omap_rtc: rtc core: registered
omap_rtc as rtc0 i2c /dev entries driver Linux video capture interface: v2.00
usbcore: registered new interface driver uvcvideo USB Video Class driver (v1.0.0) OMAP
Watchdog Timer Rev 0x00: initial timeout 60 sec hub 2-0:1.0: over-current change on port
1
usbcore: registered new interface driver usbhid
usbhid: USB HID core driver
notify_init : notify drivercreated for remote proc id 2 at physical Address 0xbee00000
Registered tvp5158 audio codec
asoc: tlv320aic3x-hifi <-> davinci-mcasp.2 mapping ok
asoc: HDMI-DAI-CODEC <-> hdmi-dai mapping ok
asoc: adv7611-hifi <-> davinci-mcasp.0 mapping ok
asoc: adv7611-hifi <-> davinci-mcasp.1 mapping ok ALSA device list:
#0: TI81XX EVM
#1: APP41
TCP cubic registered
NET: Registered protocol family 17
VFP support v0.3: implementor 41 architecture 3 part 30 variant c rev 3
omap_voltage_late_init: Voltage driver support not added Power Management for TI81XX.
omap_rtc omap_rtc: setting system clock to 2000-01-01 00:00:00 UTC
(946684800)
davinci_mdio davinci_mdio.0: resetting idled controller net eth0: attached PHY driver
[Generic PHY] (mii_bus:phy_addr=0:01,
id=1cc915)
IP-Config: Complete:
device=eth0, addr=192.168.0.68, mask=255.255.255.0, gw=192.168.0.1, host=Z3-Netra,
domain=, nis-domain=(none), bootserver=192.168.0.2, rootserver=192.168.0.2, rootpath=
Waiting 4sec before mounting root device...
PHY: 0:01 - Link is Up - 100/Full
