CONFIDENTIAL
DOC-USR-0055-03
___________________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
22
192.168.81.7, your PC would need to have an address of 192.168.x.y, where x.y is anything but
“81.07” (and not conflicting with whatever is on your current network, of course). Ensure that this
is the case. Note that the first two parts being the same are based on a value of netmask of
255.255.0.0. If netmask were 255.255.255.0, for example, then the first three parts of the IP
address would have to be the same.
After you are done, make note of the address you set your PC to. This will be important in the
streaming step.
7.6
Run the Web Interface to Configure CH1
(9)
In your PC, run a web browser (for best results, Z3 recommends FireFox). In this browser, type the
IP address of the board noted in step (7) (for example, if the default value is used, it would be
http://192.168.81.07). After about 3 seconds, the System Setup menu should come up:
(10)
Click on the “CH1” tab
(11)
You should see the Channel 1 configuration tab (see
). In this tab, change Video
Resolution to “1920x1080”, set “Output Format” to UDP and “Dest Address” to the IP address of
your PC (in this example, 192.168.0.6). Also make note of the value of “Dest Port” (should be 5004
by default).
*Note
:
If you want to encode 1080p60, you must first change “Operating Mode” at the bottom right
from “Encode Interlaced/Progressive” to “Encode Single CH No Scale.” Note that, in “Encode Single
CH No Scale” mode, only CH1 can be used.
Figure 6 Web Interface Initial Screen
