Set and unset associations:
(Note: All association information will be cleared automatically once the wall controller
is excluded from a network.)
Associations can be assigned and remove either via Z-Wave commands or using the
device itself.
1. Set association by operating primary controller/gateway to send packets to the wall
controller:
The primary controller/gateway sends packets to the wall controller using “Command
Class ASSOCIATION” or “Command Class Multi Channel Association”
2. Set association by operating the wall controller and devices to be controlled:
To control a Z-Wave device from the Wall Controller the node ID of this device needs to
be assigned to one of the four association groups. This is a three-step process:
1. Press and hold down “ALL ON/OFF” button on the wall controller for over 3 seconds,
LED indicator turns on.
2. Click any Group number button on the wall controller within 25 seconds to add the
device to be controlled to the association group, double click any Group number button
on the wall controller within 25 seconds to remove the device to be controlled to the
association group.
3. Operate the device to be controlled to send Node Information Frame (please refer to
the device manual) within 15 seconds, or set the device to exclusion mode within 15
seconds, since it will send Node Information Frame in exclusion mode, LED indications
are as follows:
LED blinks 5 times to indicate that the wall controller failed to add the associated device
(the association group has already added maximum quantity associated devices that it
supports ).
LED blinks 10 times to indicate that the wall controller added the associated device
successfully.
LED blinks 8 times to indicate that the wall controller removed the associated device
successfully.
To remove all associated devices in an association group on the wall controller directly:
1. Press and hold down “ALL ON/OFF” button on the wall controller for over 3 seconds,
LED indicator turns on.
2. Click any Group number button on the wall controller 5 times continuously within 25
seconds to remove all associated devices of this group, LED indicator blinks 8 times to
indicate that the associated devices are removed successfully.
Operating the device
