6. Changing and Saving Timing Set Value
Main Operation Screen
When Enter button pressed ‘’S’’ led will
be active and temperature set value will
be displayed.
SET Value Screen
Timer set value can be
changed with increment and
decrement buttons.
When Enter button pressed Timing set
value can be saved.
‘’S’’ will be inactive and goes back to
main operation screen.
Main Operation Screen
Timer set value parameter (Default=01:00)
Timer set value, can be programmed between minimum Timer set value 00:01 and maximum
set limit.
8
6.1 Programming Mode Parameter List
Start Type Selection Parameter ( Default =
)
Output Functions
(Default = )
Time Unit and Scale Selection
( Default = 1 )
Parameter
Hour / Minute
It can be adjusted from
to
.
Minute /Second
It can be adjusted from
to
.
Filter Time of Digital Inputs ( Default = 100 )
It is used for protection against the electrical contact debounce or the signal that is less than
the determined pulse time.
It can be adjusted from
to
msec .
Second /10 Milisecond
It can be adjusted from
to
.
Start / Stop buttons can be used to run or stop the timer.
External Start Input can only be used to run the timer. In order to stop the timer
the Stop button must be used.
External Start Input can be used to run or stop the timer.
if ON is selected timer runs by start and relay contact is closed. When time is
over, relay contact opens.
if OFF is selected timer runs by start. When time is over, relay contact is closed.
Start / Stop buttons can be used to run or stop the timer.
For detailed information refer to graphics.
