With partner, grasp two
outer legs, slightly lift off the
ground, and step backwards -
stopping at full arms’ length.
I N ITIAL SET U P
Unfold the polyester top
and place it over the
open frame.
2
Grasp the top and
bottom of the truss on
opposite sides. Slightly
lift canopy up and
push hands together
while stepping
backwards until canopy
is fully opened. Be careful not
to pinch fingers or push too hard
so as to avoid damage to truss.
2
Secure the polyester top to
the frame by attaching the
locking strips on the top
with the locking strips on
the frame.
Fully, pull the
corners down.
3
• Z-Shade Frame
• Polyester Top
Please read each step before you attempt to set up. Save these instructions for future reference.
1
IMPORTANT:
Engage support arm
by LOCKING to the
mounting bracket
between the two
sidewall washers.
Repeat on opposite support arm.
4
TAKE DOWN
With partner, slightly lift up legs, depress
push button lock to release and telescope
inner legs into outer legs.
Repeat on remaining legs.
1
4
5
• Roll Away Bag
• 4-Piece Stake Kit
Next, with each grasping two outer legs, push frame
carefully together to fully close it.
Be careful not to
pinch fingers
!
Store canopy in roll away bag.
SET U P
With partner on opposite side of
canopy, place your Z-Shade frame in
the center of area to be shaded.
Grasp outer legs, lift off the ground,
and step backwards - stopping at full
arms’ length.
1
Push
Button
Lock
Locking
Strips
To engage slider at each
corner, first lift the fabric
off of the slider. Then,
with one hand hold the
top of the leg while
PUSHING UP the push
button slider with other
hand the until slider engages.
Repeat on opposite legs.
3
Push
Button
Slider
With partner, lift
legs up and slide
out the inner
legs until the
push button locks
into outer legs.
Repeat on
remaining legs.
5
PACKAGE I NCLU DES
Height Adjustment:
Press push button
lock to release
and adjust legs
to desired height.
Repeat on
remaining legs.
Push
Button
Lock
Release sliders at
each corner by first
lifting fabric away
from slider. Then,
depress push
button to release
sliders and unlock
from truss.
Note: It’s much easier to release sliders when
the canopy weight has been removed from the
push button slider.
3
2
Ready to use -
Use stakes to
secure.
IMPORTANT:
Unlock support
arm by lifting the
mounting bracket
UP between the
two sidewall
washers; let hang
from top truss.
Repeat on opposite support arm.
Push
Button
Lock
With partner on
opposite side, grasp
top and bottom area
of trusses. Lift the
canopy up slightly
and shake it while
stepping towards
your partner until the unit is 3/4 closed.
W A R N I N G !
KEEP ALL FLAME AND HEAT SOURCES AWAY FROM ALL PRODUCT FABRICS.
THESE PRODUCTS ARE MADE WITH FLAME RESISTANT FABRIC WHICH MEETS CPAI-84
SPECIFICATIONS.
IT IS NOT FIREPROOF.
THE FABRIC WILL BURN IF LEFT IN CONTINUOUS
CONTACT WITH ANY FLAME SOURCE.
