Snap
Button
Snap
Button
Snap
Button
Locking
Strips
With partner, grasp two
outer legs, slightly lift off the
ground, and step backwards
- stopping at full arms’
length.
I N ITIAL SET U P
PACKAGE I NCLU DES
Unfold the polyester top and
place it over the open frame.
2
Grasp the top and
bottom of the truss on
opposite sides. Slightly
lift canopy up and push
hands together while
stepping backwards
until canopy is fully
opened. Be careful not
to pinch fingers or push
too hard so as to avoid
damage to truss.
2
Engage Pull Pin slider at
each corner by pushing
up on slider with one
hand while holding
down on top of leg with
other hand. Pull Pin will
engage in hole.
Repeat on opposite Legs.
3
Secure the polyester top to
the frame by attaching the
locking strips on the top with
the locking strips on the
frame. Pull the corners down
fully.
3
• Z-Shade Frame
• Polyester Top
Please read each step before you attempt to set up. Save these instructions for future reference.
1
With partner,
lift outer legs
up and slide out
the inner legs
until the snap
button locks into
outer legs.
5
Engage Support
Arm by locking to
the mounting
bracket between
the two sidewall
washers.
Repeat on opposite Support Arm.
4
NOTE:
Remove
Support Arm by
lifting the
mounting
bracket up
between the two
sidewall washers and let hang from
top truss.
Repeat on opposite Support Arm.
2
Lift up the remaining two outer legs up and slide out
the inner legs until the snap button locks into outer
legs.
Use stakes to secure if windy conditions.
6
TAKE DOWN
With partner, slightly lift up adjacent outer
legs, depress snap button to unlock and
telescope inner legs into outer legs.
Repeat on opposite Legs.
1
4
5
Grasp top and bottom area
of trusses. Lift the canopy up
slightly and shake while
stepping towards your
partner until 3/4 closed.
With each partner grasping
two outer legs, push frame
together to fully close it.
Be careful not to pinch fingers!
• Roll Away Bag
• 4-Piece Stake Kit
With partner on opposite side, grasp top and bottom
area of trusses. Lift the canopy up slightly and shake
it while stepping towards
your partner until the unit
is 3/4 closed. With each
partner grasping two
outer legs, push frame
together to fully close it.
Be careful not to
pinch fingers
!
Store canopy in roll away bag.
SET U P
With partner on opposite side of
canopy, place your Z-Shade frame in
the center of area to be shaded.
Grasp outer legs, lift off the ground,
and step backwards - stopping at full
arms’ length.
1
Pull
Pin
Release Pull Pin at each corner
by first lifting fabric away from
slider. With one hand push up
on truss near the Pull Pin, pull
the pin out to release.
NOTE: It is much easier to
release Pull Pin when the canopy
weight has been removed from
the Pull Pin.
3
WARNING: Keep all flame and heat sources away from all product fabrics. These fabrics meet
the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact
with any flame source. The application of any foreign substance to the fabric may render the
flame-resistant properties ineffective.
