11
3.ASSEMBLING OF HOPPER
Insert Hopper Top Assembly I (46) into Hopper Bottom Assembly (2), align the holes. Make
sure hopper opens to the front (control side). Insert the Bolts (I) through the holes in the
Hopper and Kep Nuts (J), then open the Hopper Lid and tighten it from inside. The four sides
are installed in the same way.
Usage of Pellet Cleanout Door
Note: The Hopper is equipped on the back with a Pellet Cleanout Door to clear the hopper of
unused pellets so as to replace with fresh pellets or pellets of a different smoking flavor.
1. Place a bucket or bowl below cleanout door to capture falling pellets.
2. Turn cleanout door thumbscrew counterclockwise to unlock door, and pellets will fall
through cleanout chute. (Don’t remove the thumbscrew completely.)
3. Once pellets have dispensed through chute, lower the door down. Turn thumbscrew
clockwise to lock door.
