Z-RF Encode 001 Manual V.1
Rev 5.4.21
13
Section 4: RF Output Setup
Step 3:
RF Output Setup
1.
Select the ‘RF Output Setup’ tab from the top menu.
2.
Modify all parameters as needed.
Use the Output Setup page to set the RF output type, RF Output CH/frequency, and Constellation.
1.
Modify and set the required parameters for your installation
TSID: (Factory Default is 1)
* If installing multiple units in the same system – ensure each device has a unique TSID.
2.
Select and set the RF Type.
RF: Normal, Inverted (Factory Default is Normal)
3.
Select and set Channel Type.
Channel Type: J.83B STD, J.83B HRC, J.83B IRC (Factory Default is J.83B STD)
4.
Select and set the required CH/Freq.
CH/Freq QAM.: Factory Default is 102 (CH range 7-135, Freq. range: 177~ 861MHz)
5.
Select and set the required Constellation.
Constellation (QAM TYPE): 256 QAM, 64 QAM (Factory Default is 256)
Save and Confirm all changes settings on RF Output Setup page.
Application Note:
When installing more than 1 device into a system, each device must have a unique RF TS_ID.
We highly recommend you save your encoder configuration files.
See Administration tab for how to backup device settings.
Note: To reset all changes made or saved go to the Administration Page and select 'Reset to Default'.
*Leaving the RF Output Setup page without saving changes will cause the previous settings to be used.
- If the unit is outputting video to the system
