www.z-band.com/866-902-2606
17
“GigaBUD 1000” Installation Guide
Satellite (Unlocked)
The lights for this mode indicate that the unit is a Satellite unit. A blinking
amber
light means there is
a RF signal on the “Cascade In” port. Unlocked means the System is self-adjusting to set itself to the
proper levels based on distances between itself and the Master unit. Once it has settled, it will ap-
pear as 3 green lights as shown below.
Satellite (Locked)
After about a 10 seconds, the unit will lock in the parameters it has adjusted to for a balanced
System. The amber light will no longer blink and remain solid
green.
Note: If power is disrupted, the
unit will return to native state.
“GigaBUD 1000” FUNCTIONS:
Master
Satellite
While in Master and the button is held for ~5 seconds, the unit will stop broadcasting the tone and the
light will change from yellow to green. Holding the red button again will turn the tone back on. Resetting
the power from this point will return the unit to master with the tone being broadcast.
While in Satellite mode with no feed into cascade in and the button is held for ~5 seconds, the unit will
switch to a native state, all four lights will be on. When a feed is present then the red button
Function is disabled.
CATV
Inbound
Outbound
Cascade
In
Cascade
Out
FIBER
INPUT
90-264 VAC
47-63Hz
150W
2A Fuse
RED BUTTON PURPOSE:
MASTER SLAVE
RF VIDEO
BROWSER
PORT
GigaBUD
IP
POWER
STATUS
Video Hub
1000
4
2
6
10
12
MASTER SLAVE
RF VIDEO
BROWSER
PORT
GigaBUD
IP
POWER
STATUS
Video Hub
1000
4
2
6
10
12
Figure 16
