www.z-band.com/866-902-2606
16
“GigaBUD 1000” Installation Guide
FRONT INDICATORS AND RED BUTTON ON REAR:
Initial Power-Up
All four lights indicate the System is searching for a source and whether it will be a Master or a
Satellite unit. Depending on what source is connected will provide the light sequence indicated as
shown below. When this light sequence is shown, the unit will be in “Native State”.
When there is a signal that goes into “CATV IN” port or the “FIBER IN” port the
Red
master light turns
on. The pilot tone is a unique signal sent out so that the Satellite units connected can set their levels
properly for signal balance. A
yellow
“Fourth” light indicates that the pilot tone is on and is active.
Master (CATV Wired or Fiber) Pilot
Master (CATV Wired or Fiber) Pilot
While a feed is hooked into CATV and then red button is held down the pilot tone will be switched
off. A
green
light on the fourth position indicates that the pilot tone is turned off.
MASTER SLAVE
RF VIDEO
BROWSER
PORT
GigaBUD
IP
POWER
STATUS
Video Hub
1000
4
2
6
10
12
MASTER SLAVE
RF VIDEO
BROWSER
PORT
GigaBUD
IP
POWER
STATUS
Video Hub
1000
4
2
6
10
12
MASTER SLAVE
RF VIDEO
BROWSER
PORT
GigaBUD
IP
POWER
STATUS
Video Hub
1000
4
2
6
10
12
Figure 15
