6
II. Preparations for Flying
Aircraft power-on, initialization is completed, backlight state, then you can unlock motors
After the motors has been unlocked
,
backlights state, then you can push up the throttle to take off
During flying ,voltage alarm
Aircraft backlight Signal indication
A.Backlight
flashes
RED
-
YELLOW
-
GREEN
this
indicates
initialization is completed but
without
GPS
signal
.
A.Backlight
flashes
this indicates Seraphi is unlocked, but no GPS signal.
B.Backlight turn off , this indicates Seraphi is unlocked ,with
GPS signal.
A.During flying
,
backlight
flashes
RED
-
GREEN
this
indicates
voltage alarm
,
no GPS signal
.
B.Backlight
flashes
GREEN
this
indicates
initialization is completed.
with
GPS
signal
.
B.During flying
,
backlight
flashes
GREEN
this
indicates
voltage alarm
,
with GPS signal
.
I.Flying warnings
1
.
For the first flying, beginners are strongly suggested taking necessary trainings by professionals or doing some pre-exercises on
simulators until you can skillfully operate the aircraft or the simulator and the
remote controller
2. During flying, please make sure that Seraphi is always within sight and its back light always faces its operator so that he could
determine its flight attitude and adjust its flight directions when necessary.
3. During flying, what's more, please watch the flash of back light at any time and keep alert to Low-Voltage signals. Low-Voltage Alert is
to indicate that the battery cannot provide enough power for the aircraft and you should land the aircraft
to avoid or reduce crashes
ASAP
4. Sensors in the heart of SeraphI are damageable, so be sure not to hit or drop the aircraft heavily. Otherwise, the inertial measuring unit
(IMU) might be destroyed. If Seraphi flies in an abnormal way after being hit or dropped Seriously, please return it to Yunyi-Flight to repair
immediately.
Place seraphi on horizontal ground, power on .when
backlight
flashes GREEN-YELLOW-RED or flashes GREEN Pull the
up switch bottom in GPS mode , Pull the left and right stick to
the left bottom at same time, back light flash rapidly, release
the sticks, Afer 10 seconds, when backlight flashes GREEN-
YELLOW-RED or flashes GREEN ,horizontal calibration is
successfu
l.
Horizontal calibration
Steps
NOTE:
1.In any Drop or
rollover cases or the first use or
did not use it for a long time
.
You should carry out this step. This will ensure a stable
flight .
2.you should ensure
the
aircraft put on a horizontal ground,keep
it
still,do not move seraphi during calibrating.
Battery
1. Do not disassemble or reconstruct battery.
2. Do not short-circuit battery
3. Do not use or leave battery nearby fire, stove or heated place(more
than 80 ℃)
4. Do not immerse the battery in water or sea water , or get it wet
5. Do not charge battery nearby the fire or under the blazing sun
6. Do not drive a nail into the battery. Strike it by hammer, or tread it
7. Do not give battery impact or fling it
8. Do not use the battery with conspicuous damage or deformation
10. Do not reverse charge or overdischarge the cell
11. Do not reverse-charge or reverse-connect
12. Do not connect battery to the plug socket or car-
cigarette-plug
13. Do not use battery for unspecified equipment
14. Do not use Lithium ion battery in mixture
15. Keep the battery away from babies
16. Do
not
get into
a microwave or a high pressure
container
17. Do not use a leaked battery nearby fire
18. Do not use an abnormal battery
