YUNEEC Proaction CGO4, User Manual

Page: 7 / 29

AERIAL IMAGING SOLUTION
ATTACHING CGO4 GIMBAL CAMERA TO MULTICOPTER
STEP 1)
：
Mount the Rubber Dumpers to H920 fixing eyelet, install the two thread-off proof
screws to fix the gimbal damping plate and then tighten all the screws.
STEP 2)
：
Insert the Gimbal Connection Cord to the inner side of Gimbal Damping Plate
(relative to the direction of H920 Power Connection Port)
STEP 3)
：
Mount the Gimbal Thumb Screws and lock
washers (4 pcs) to the Gimbal and rotate the screws until
they’re secured into the Gimbal Damping Plate.
STEP 4)
：
Connect the Gimbal Power Cord to H920 Power
Connection Port.
NOTICE: The “Front” of the gimbal camera should be
installed in the direction of the nose of H920.
NOTICE: Use the dedicated lock washers when rotating the screws
BINDING CGO4 GIMBAL CAMERA TO THE ST24 (SINGLE MODE)
STEP 1): Power on the ST24, press [ ] button to go to the main interface. Choose FPV, and
enter Model Select.
STEP 2): The default Model type is Multi-copter. Tap the “H920 CGO4” icon and press OK to
enter the flight control interface.
NOTE: The pre-set model in the “Model Select” interface cannot be deleted.
NOTE: The pre-set model can only be bound to one multi-copter. If the user wants to bind to
the other copters, press and hold the “H920 CGO4” icon, select “copy” on the pop-up menu.
Wait for a few seconds and then tap the newly created icon. Press OK to enter the flight
control interface.
STEP 3): Switch on the TORNADO H920. Wait for a moment until the H920 Main LED indica-
tor blinks blue, the CGO4 LED indicator blinks green and
then start the binding procedures.
STEP 4): Lean the H920 in the forward direction twice
(45°), until the Main LED indicator blinks yellow.
STEP 5): Tap the Refresh icon, and the codes of the H920
and CGO4 will be shown on screen. Choose the right
codes and press Bind.
STEP 6): If it is the first time to bind your CGO4 to the
ST24, you need to insert the password: 1234567890. Press OK on the pop-up window to continue.
STEP 7): Press Camera Select and choose CGO4. Press Select, then press OK.
CGO4
STEP 2 STEP 5
NOTICE: We recommend users to power on the aircraft in the angle mode.
NOTICE: When returns back to the FPV interface, you will hear two long beeps. That means
the binding is complete. The Real-time images can now be seen on the screen.
5