Fitzroy Install NOV 2010
www.yunca.co.nz
Page 2 of 4
FITZROY SUB 1.0 – TYPICAL INSTALLATION
(not drawn to scale)
FIG A (below, left):
FITZROY Sub 1.0 Flue Mounted Shield (Flue Guard) Kit.
Complies (with heater) to AS/NZS 2918:2001
5mm Max
50
LINER POSITIONED BY SPIDER
BRACKETS. TOP/BOTTOM
FLUE
TOP CAP (Fits inside flue)
FLASHING
25 MM BETWEEN LINER
AND ANY TIMBER.
TIMBER RAILS
SUPPORT ANGLES
25 mm min BETWEEN LINER
& ANY TIMBER
LINER POSITIONED BY SPIDER
BRACKETS TOP & BOTTOM.
SUPPORT ANGLES
300mm sq TIMBER FRAME
CEILING
1200mm BACK GUARD
TERTIARY
BACK GUARD
TWO SEISMIC RESTRAINT
attachment points.
6
0
0
m
m
A
B
O
V
E
T
H
E
R
ID
G
E
L
IN
E
(
M
IN
)
*
*
If
w
it
h
in
3
.0
m
o
f
ri
d
g
e
l
in
e
*
1200mm FRONT GUARD
4
.6
M
.
M
IN
IM
U
M
ASH FLOOR
PROTECTOR
650
300
100
900 Extension
Top Front
Angled
Lined
Deflector
65mm Gap
Note: All measurements are in millimetres. The rear
clearance from the top rear lip of the fire is 100mm,
i.e. 120mm from the (recessed) rear panel.
CONDITIONS FOR FLUES
(Refer Fig. E)
1. The FLUE shall extend to:
Not less than 600mm above the highest
point on the roof if within 3.0m of that
point, or
Not less than 1000mm above the
intersection point with the roof and not
lower than any point of the roof within
3.0m.
In any case the length of the flue shall
not be less than 4.6m from the ash floor
protector.
In some situations the Local Council
may vary the above requirements.
2. The flue system must be tested and
comply with AS/NZS2918:2001,
Appendix F.
3. The insulation boundary shield shall be
capable of preventing accidental
migration of loose-fill or any
combustible material by any action of
wind or by persons moving in the ceiling
space.
These instructions, spare parts information, operation and maintenance guides may be
downloaded from our website
www.yunca.co.nz
CEILING PLATE
25mm min. BETWEEN LINER & ANY TIMBER
ENLARGEMENT OF CEILING ASSEMBLY
30
0
300mm Sq. TIMBER FRAME
TIMBER RAILS
SUPPORT ANGLES
LINER POSITIONED BY SPIDER
BRACKETS. TOP/BOTTOM
INSULATION BOUNDARY SHIELD
CUT CEILING MATERIAL
BACK 25mm CLEAR
OF BOUNDARY SHEILD.
CEILING
25
300
FIG B
