Revised 27/05/10
ALLURE Outdoor Install May2010
Page 3 of 17
CAUTIONS
:
This installation and any future service or repair work must be carried out by a suitably qualified
person and comply with the current New Zealand (Australian installation code) NZS 5261:2003
(AG 601:2002)
This appliance should be serviced at least annually by a qualified service person.
Control valve compartments, burners, and air circulating passageways of the
ALLURE
must be
kept free from any lint and dust build-up to ensure efficient and safe operation of the fire.
DO NOT PLACE ARTICLES ON OR AGAINST THIS APPLIANCE.
DO NOT USE OR STORE FLAMMABLE MATERIALS NEAR THIS APPLIANCE.
DO NOT SPRAY AEROSOLS IN THE VICINITY OF THIS APPLIANCE WHILE
IT IS OPERATIONAL.
NEVER OPERATE THE FIRE WITH THE COVER IN PLACE.
STAINLESS STEEL FASCIAS and WEATHER COVERS…
are shipped with protective plastic in place to reduce the risk of damage
in transit.
ONLY remove this plastic immediately before fitting the fascia to the fire.
Do not use abrasive cloths or cleaners on stainless steel fascias. Use
only specialised Stainless Steel cleaners available from your local
hardware store.
MAINTENANCE
YUNCA GAS HIGHLY RECOMMENDS THAT a qualified service person should
conduct an annual inspection and undertake any maintenance required on
your Yunca Allure.
Its venting and installation must be checked to keep it running safely and
efficiently.
Procedures should be performed only by a qualified service person.
The gas supply should be isolated whenever any maintenance procedures are
undertaken.
