User Manual
User Manual
User Manual
User Manual
TW 600
TW 600
TW 600
TW 600
Gate 1
Gate 2
Shot Short
Gate 1
Gate 2
Gate 2
Gate 3
Gate 5
Gate 1
Gate 4
7. Connector position and Assembly
1) Connector is installed to Solenoid Block Assembly in mold.
2) Connector Assembly
Connector Pin No
1, 2
3, 4
5, 6
7, 8
9, 10
11, 12
13, 14
15, 16
Sol Valve No
No. 1
No. 2
No. 3
No. 4
No. 5
No. 6
No. 7
No. 8
HAN 16A (250V 16A)
Mold : Male Insert
(09 20 016 2612 )
Cable : Female Insert
(09 20 016 2812 )
Connector
사양
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
6. Sequence system application
SEQUENCE INJECTION TIMER
SEQUENCE INJECTION TIMER
9
10
Gate 1
Gate 3
Gate 2
Gate 4
Gate 5
1) MODE A application
(1) In case of short shot on product
Open Gate 1 first to enlarge filling area, then Open Gate 2 later to fill up well.
(2) To inject products which have a big dimensional difference per cavity,
open G1 first to fill up the big size and then open G2 later to make
the balance. It can optimize the injection precision.
2) MODE B application
(1) To inject complicated products which have a big dimensional difference,
apply MODE 1 for Gate 1~4, and MODE B only for Gate 5. It is used to
fill up the very small sized dimension just before the injection ends.
3) MODE C application
(1) It is used to apply 'one and after' injection signal control.
Opening the gates first which could have fill-up Unbalance if Users
open the all gates at the same time, and then close the gates keeping
time with fill up. It is designed to avoid the excessive filling pressure.
Although this is also possible in MODE B operation, the function to
keep up the holding pressure in channel by opening the Gate (The Timer
controller itself keeps the injection signal in an open condition )
is possible only in MODE C. MODE C is a new type of output pattern
which is able to optimize the various sequence controls to match the
product feature and injection peculiarity.
