9
Unwrap throttle from carb. Install carb. on intake tube and choke lever on handlebar.
Install external CDI module on down tube as far away from engine heat as possible.
First install Blue & Black wires from engine magneto to same color CDI wires.
Warning:
Do not hook up backwards or damage will occur to the CDI.
Next install the throttle
handle kill switch wires into the 2 remaining open holes of the 2 CDI wire terminals. Push
the clear rubber protectors over the 2 connections and tape with black electrical tape. The
remaining white wire from the engine is not needed unless you want to run a small wattage
6V headlight but it’s not recommended as it will rob engine ignition power requirements so is
really best to tape this wire up securely or just snip it off at the engine exit plug. To keep
water out of the magneto box use a heat shrink tube over the wire sheathing.
Blk.
wire from engine to Blk. of CDI
Blue
wire from engine to Blue of CDI
Two kill switch wires can go to either of the remaining 2
empty holes of the CDI terminals, color code is not important.
For CDI Color code is very important:
Like to Like.
Optional 2010 YD CNS Carb.
