11
For GT5-SR and GT2-SM use this kill switch hook up;
2010 / 2011 models have a special CNS YD EPA Carb. especially for Skyhawk engines.
This new carb. has adjustment screws sealed and has an external cable choke control. Be sure to
check carb. air cleaner attach screws for tightness before installing engine in frame: Air cleaner
screws coming loose and entering engine is not warranty; CNS Carb. Service repair kits are available:
Procedure for attaching throttle cable to carburetor throttle slide: The small stop on the cable wire end slides
through the long groove on the slide valve. Cable comes hooked up to carb. for trouble free installation.
( Note component positions in pictures; Needle clip is factory set in second slot: )
The spring is placed inside the cylinder slide and is compressed when the throttle is twisted. Be sure it is
seated all the way inside the cylinder. The spring then forces the throttle to return. For this to work properly
the throttle must twist freely on the handle bar in both directions prior to the cable being installed.
A)
Install twist grip throttle on right side of handlebar end. On some handle bars it may be necessary to
ream out the handle ID to fit the bar so that the throttle will twist freely.
GT5SR & GT2-SM Kill
switch wires can go to
either wire from engine.
