5
•
Open the battery compartment on the rear side of the receiver and insert the batteries
by observing the correct polarity. Close the battery compartment.
•
When you insert the batteries all the segments on the display will briefly light up and
you will hear a short tone.
•
Then, within approx. 15 secs, you may set the height above sea level at your place
and the weather icon following the current weather condition. Plus the unit of the
pressure display (hPa or inHg). This setting can also be made later.
•
The weather station will then start to connect to the outdoor sensor and thus ready to
begin transmitting data. This operation takes about three minutes and is displayed by
a flashing reception symbol in the ”OUTDOOR” display area.
•
After the weather station has created a connection to the outdoor sensor, it will then
commence automatic reception of the DCF77 Radio Signal for the Radio Controlled
Clock. This operation could take up to twenty-four hours and the on-going reception is
displayed by the flashing radio mast symbol in the “Clock” display area. The best time
to catch the radio time signals is at night.
•
If reception is successful, then the radio mast symbol will appear continuously in the
display.
If this automatic setting process is unsuccessful, then use a sharply pointed instrument to
press the Reset button on the rear side of the receiving station (in the battery
compartment, above the batteries).
If you encounter poor reception on the radio control clock, which results in the inability to have
the time set automatically, please use this manual setting procedure listed below.
