YTL COX 32T, Owner'S Manual

Page: 16 / 21

- 16 -
Problem
Cylinder rod will not move SOLUTION: A,D,E,H,J
Slow cylinder rod speed when extending or
retracting SOLUTION: A,B,C,H,I,K,L
Wood will not split or splits extremely slowly SOLUTION: A,B,C,F,I,K
Engine bogs down during splitting
SOLUTION: G,L
Engine stalls under low load condition SOLUTION: D,E,L,M
Problem when starting the engine SOLUTION: N
Cause Solution
A
-Insufficient oil to pump Check oil level in reservoir
B -Air in oil Check oil level in reservoir
C -Excessive pump inlet vacuum Check pump inlet hose for blockage or
kinks
D -Blocked hydraulic lines Flush and clean the splitter hydraulic
system
E -Blocked control valve Flush and clean the splitter hydraulic
system
F -Low control valve setting Adjust control valve with a pressure gauge
G -High control valve setting Adjust control valve with a pressure gauge
H -Damaged control valve Return control valve for authorized repair
I
-Internal control valve leak Return control valve for authorized repair
J -Internal cylinder leak Return cylinder for authorized repair
K -Internally damaged cylinder Return cylinder for authorized repair
L -Engine Control out of adjustment Adjust idle control nuts
M -Engine is loaded during idle down mode Use shorter log length (26” or less) to allow
engine to speed up before contact.
N -Engine operation Refer to the English owner’s manual
Troubleshooting