Weather icons flashing / blinking is fine , which mean weather station thinks,
that weather will be between two icon or will or may change rapidly
or rainy/stormy
Accuracy of the Weather forecast icons is about 70% , its written in the user
manual but as we are UK , weather changes here like no tomorrow.
this is how it works , analysing air pressure all the time , it will change in due
course when weather station data thinks and value will go up or down for
your pin point location ( Automatically ) , this cannot be changed manually . it
will settle down in due course . as and when your weather station feel fit to do
so ,
F.Y.I.:
The Snowy icon will only appear if the outdoor temperature is below -4
℃
(+25
℉
) and the forecast would be
rainy or stormy,
By default, according to the temperature of CH1, when there is no signal in CH1, it is calculated
according to the temperature of CH2. When there is no signal in CH1 and CH2, it is calculated according to the
temperature of CH3.
After the weather station needs 7-10 days of air pressure calibration, the weather forecast will tend to be stable
with an accuracy rate of 70%
The forecast can be given for a radius of up to 12-20km.
The weather station can display the barometric pressure trend.
You may see the following displays:
: The barometric pressure will rise.
No display: The barometric pressure will remain constant.
:
The barometric pressure will fall.
Reception of the Radio signal:
The clock automatically starts the
MSF
signal search after 7 minutes of any restart or changing of new fresh
batteries. The radio mast icon starts to flash.
At 1:00 /2:00 / 3:00, the clock automatically carries out the synchronization procedure with the
MSF
signal to
correct any deviations to the exact time. If this synchronization attempt is unsuccessful (the radio mast icon
disappears from the display), the system will automatically attempt another synchronization at the next full one
hour. This procedure is repeated automatically up to total 5 times.
To start manual
MSF
signal reception, press and hold down the “
▲
” button for
two seconds. If no signals
received within 7 minutes, then the
MSF
signal search stops (the radio mast icon disappears) and start again at
the next full one hour.
During MSF radio signal reception
，
to stop searching radio signal, press and hold down the “
▲
” button for
two
seconds.
F.Y.I.:
A flashing radio mast icon indicates that the
MSF
signal reception has started
18
