Young Living Home Diffuser, Operating Manual

Page: 5 / 44

5
Operating Instructions
1. Open the water reservoir by lifting the lid. Add room-temperature
water (distilled water is recommended) into the reservoir up to the fill
line. Do not exceed the fill line.
2. Add 8-12 drops of your favorite Young Living essential oil into the water.
3. Replace the lid to cover the water reservoir.
4. Plug in the Home Diffuser and push the power switch to start diffusing.
5. When water runs out, the diffuser will automatically shut off.
6. Press the power switch to cycle through the three-mode setting:
Mode 1: Green light - Constant diffusion
Mode 2: Red light - 30 seconds intermittent diffusion
Mode 3: Off
7. Press and hold the power switch for approximately 2 seconds to turn
on/off the ambient LED light.
Notice: Due to the mist output of the Home Diffuser, use caution on
surfaces that are sensitive to water.
Cleaning
Always turn off and unplug the Home Diffuser prior to cleaning. To ensure
proper performance, clean the ultrasonic plate and lid after each use. If
essential oil begins to build up on the ultrasonic plate, gently wipe it off
using the included cleaning sponge or a cotton swab dipped in rubbing
alcohol. If essential oil begins to build up on the lid, gently wipe it off using
mild soap and water only. Periodically check under the diffuser to keep
the fan intake free of debris. Debris can be removed by blowing on the
intake opening or wiping with a clean, dry cloth. (Do not use aerosol sprays,
solvents, or abrasives to clean the plastic housing.) When not in use, clean
the Home Diffuser and store dry.
Notice: When removing excess water from the reservoir, pour water
from the opposite side of the air inlet to avoid spilling on the operating
buttons or getting water in the internal air inlet.