aquaMAX
TM
-Basic 360 Series
4-2. Filter Replacement
［
Figure 4-2
］
Filter Replacement
①
Close the feed water.
Push the
②
Service
key and
Select
key at Standby mode to perform “pressure down”. Perform it twice.( It takes
about 8 sec at one time) . Run “Change Filter” to replace filter when the filter life is done.
③
Open the door to replace filters.
*
Take out the filter using a tool for use of filter replacement.
(Once hearing the "click" sound from the clip, grab the filter and slowly pull it out.)
* After separating the filters, press the housing by making sounds like “ click”.
* Connect the filters by each name. (The right connection makes sounds like “ click”.)
* For the R.O membrane pack, press down the fitting clip on the lower part of filter making a sound like "click"
to remove the connected fitting.
☞
CAUTION : Put a beaker at the external end of drain tube in case small amount of waste water can be
drained.
④
Open the feedwater.
⑤
Run “ Flush” on
「
Standby
」
mode.(
Service
key
Æ
Select “Flush”.)
29
