6
Attaching the Crib Base Rails
Step 1:
x
Using a Flathead Screwdriver, align the slots in the Barrel Nuts with the holes for
the connector bolts located in the Base Rail . See Figure 1a.
x
Align the holes in the Base Rail with the holes in the Crib Ends and insert (4)
3 1/2”
connector bolts from the outside of the Crib Ends. Make sure the Brackets attached
to the Base Rail are facing the inside of the Crib. See Figure 1b.
x
Repeat Steps for opposite Side Rail.
x
Do not completely tighten the connector bolts at this time.
Figure 1a.
Figure 1b.
Figure 1a.
Barrel Nuts
Figure 1b.
Figure 1b.
Step 2:
x
Install (6) Locater Pins.
x
Locate the threaded insert in the top edge of each
Base Rail and insert a Locater Pin. Tighten by
hand. See Figure 2a.
x
Locate the top inserts in each of the Crib Ends and
insert a Locater Pin. See Figure 2b.
Figure 2b.
Figure 2b.
Figure 2a.
Figure 2a.
