5.2.5.
Install a motor arm
Preparation
Make sure that the rubber suspension is installed on the carrier.
Procedure
1.
Put the motor cable through the carrier.
Do not connect it yet.
2.
Make sure that the rubber suspension is
installed on the frame.
3.
Make sure that the distance holder (C) and
the bearings are installed in the frame.
4.
Hold the motor arm (B) and carefully place it
on the carrier.
5.
Fasten the screw (A) to connect the motor
arm to the carrier frame.
Use some Loctite 648 to secure the screw.
6.
Connect the motor arm to the rubber
suspension and install the locking ring.
7.
Connect the motor cable to the
interconnection of the power module.
C
A
B
5.2.6.
Replace a drive wheel
Preparation
See section
5.1.
Procedure
1.
Lift the wheelchair until the wheels are free from the floor.
•
Use a lifting platform.
2.
Remove cap A.
3.
Unfold the washer (C).
4.
Remove screw B.
5.
Remove the old drive wheel.
•
Make sure that you do not loose the
key (D).
6.
Install the drive wheel.
a. Put some grease on the axle to prevent
fretting.
b. Mount the drive wheel on the axle.
c. Make sure to lock the nut by folding the
washer.
7.
Make sure that the drive wheel does not
interfere with the motor.
C
D
C
A
B
Maintenance tasks & adjustments
18
Service manual - Liam
