1. Remove rider seat.
2. Remove left and right rear side cover as per
Factory Service/Owners Manual.
3. Remove the four bolts securing the seat bracket
plate to the frame.
4. Locate and disconnect the license plate light
and rear turn signal connectors.
5. While supporting the stock fender assembly,
remove the four nuts securing the fender
assembly to the frame.
Note: Take precaution when removing the stock
fender assembly and avoid snagging the
stock license plate light and turn signal
connectors as they will be re-used.
6. Remove the plastic key hole cover from the
stock fender assembly.
Note: Key hole cover will be re-used. Do not
damage during disassembly.
7. Remove left and right turn signals from the
stock fender assembly.
8. Cut the stock license plate light connector wires
on the stock fender assembly side. Be sure to
cut at least a 6” section of wire from the
connector.
Removal
Installation
1. Install (No. 3)
070BG-LH-K1,
Yoshimura license
plate light onto (No. 2)
12200-FEBKT,
Yoshimura license plate bracket
using (No. 7)
M4X6BHS,
4mm button head screws provided
in the kit.
2. Install (No. 1)
13100-FEBKT,
fender eliminator
bracket using (No. 11)
M6X20BHS,
6mm button
head screws along with the stock nuts.
2
3
7
3. Install (No. 2)
12200-FEBKT,
license plate
bracket onto (No. 1)
13100-FEBKT,
fender
eliminator bracket using (No. 8)
M6X10BHS,
6mm button head screws as shown in the
diagram below.
8
2
1
3
4. Install the stock plastic key hole cover onto
(No. 1)
13100-FEBKT,
fender eliminator
bracket by inserting the key hole cover pins into
holes
A
and
B
.
Note: Check fitment and function of plastic key
hole cover. Confirm that the plastic key
hole cover is secure. If required, adjust
13100-FEBKT
, fender eliminator bracket
by pinching the two sides and tightening
the four mounting screws.
5. Using the
BN-SSS-22-18
butt connectors
provided in the kit, connect the Yoshimura
license plate light wires to the stock license
plate light wires as follows:
Blue w/ Red Stripe -to- Red Wire
Black Wire -to- Black Wire
a) Strip the stock fender light wire ends
1/4” - 1/2” and insert into
BN-SSS-22-18,
butt connectors provided in the kit.
b) Center the spliced wire ends in the
middle and using a heatgun or lighter,
apply heat evenly on the outer edges of
the butt connector to shrink and hold
wires in place.
A
B
