5168276-XIM-B-0216
54
Johnson Controls Unitary Products
1034349-UCL-C-0315
2
Unitary Products Group
SAFETY WARNINGS
The inspections and recording of data outlined in this procedure
are required for start-up of Johnson Controls/UPG's packaged
products. Industry recognized safety standards and practices
must be observed at all times. General industry knowledge and
experience are required to assure technician safety. It is the
responsibility of the technician to assess all potential dangers
and take all steps warranted to perform the work in a safe
manner. By addressing those potential dangers, prior to
beginning any work, the technician can perform the work in a
safe manner with minimal risk of injury.
NOTE:
Read and review this entire document before beginning
any of the startup procedures.
DESIGN APPLICATION INFORMATION
This information will be available from the specifying engineer
who selected the equipment. If the system is a VAV system the
CFM will be the airflow when the remote VAV boxes are in the
full open position and the frequency drive is operating at 60 HZ.
Do not proceed with the equipment start-up without the
design CFM information.
Design Supply Air CFM: __________________________ Design Return Air CFM: ______________________________________
Design Outdoor Air CFM At Minimum Position: ________________________________________________________
Total External Static Pressure: _____________________________________________________________________
Supply Static Pressure: __________________________________________________________________________
Return Static Pressure: __________________________________________________________________________
Design Building Static Pressure: ___________________________________________________________________
Outside Air Dilution: Economizer Position Percentage: ___________________________________ _ CFM:
________________
Supply Gas Pressure After Regulator W/o Heat Active ___________________________ Inches_________________
ADDITIONAL APPLICATION NOTES FROM SPECIFYING ENGINEER:
Lethal voltages are present during some start-up
checks. Extreme caution must be used at all times.
Moving parts may be exposed during some startup
checks. Extreme caution must be used at all times.
