5011492-XIM-B-0815
30
Johnson Controls Unitary Products
Figure 16: Unit Dimensions (Rear View)
mm[inch]
445
[17
1
/
2
]
445
[17
1
/
2
]
165
[6
1
/
2
]
292
[11
1
/
2
]
76 [3]
200
[7
7
/
8
]
117 [4
5
/
8
]
292
[11
1
/
2
]
Figure 17: Disconnect/Blower Access Location
Table 16: UTILITIES ENTRY
HOLE
OPENING SIZE (DIA.)
(mm/in)
USED FOR
A
22 / 0.88 KO
1
Control Wiring
2
Side
Bottom
B
51 / 2.0 KO
1
Power Wiring
Side
Bottom
C
41 / 1.63 KO
Gas Piping (Front)
D
38 / 1.5 KO
Gas Piping (Bottom)
1. Opening in the bottom to the unit can be located by the
side in the insulation.
2. Do not remove the 2” knockout ring.
Disconne
c
t Switch Location
and Motor Access Panel for
Unit with “Belt-Drive” Option
Control Box Access
A,B
Wiring Entry
(See Detail “B”)
Mounting Bracket for
Disconnect Switch
(Field Supplied)
Field-Supplied Disconnect
Switch Location
Blower Motor Access
Filter Access
Dot Plugs
Table 17: Minimum Clearances
LOCATION
CLEARANCE (mm / In.)
Front
610 / 24.0 (Cooling/Electric Heat)
813 / 32.0 (Gas Heat)
Back
305 / 12.0 (Less Economizer)
914 / 36.0 (With Economizer or
Fixed Air/Motorized Damper)
Left Side (Filter Access)
610 / 24.0 (Less Economizer)
914 / 36.0 (With Economizer)
Right Side (Cond. Coil)
610 / 24.0
Below Unit
1
0
Above Unit
2
1829 / 72.0 (For
Condenser Air Discharge)
1. Units may be installed on combustible floors made from
wood or class A, B, or C roof covering material.
2. Units must be installed outdoors. Overhanging struc-
tures or shrubs should not obstruct condenser air dis-
charge outlet.
