York Fitness 56020, Owner'S Manual, Page: 13 / 24

www.yorkfitness.com 13
Power On
LCD will display all segments, beep, and enter scan mode.
Stand-by Mode
The monitor will enter Stand-by mode if there is no signal for 4 minutes. Press any key to wake the console up.
Operation
1. When monitor powers on (Press MODE, RESET key and hold for 3 seconds), LCD will display all segments and
enter SCAN mode.
2. When the monitor detects a signal, the value of TIME, COUNT, DISTANCE, CALORIES and TOTAL CNT will start
to count up.
3. If there is no signal transmitted into the monitor for 4 minutes, the monitor will enter Stand-by mode.
Troubleshooting
If you have a problem with your rower, before you do anything else please check that all the cables have been
connected correctly. Loose cables are very common and many problems can be solved by making sure the cables
are properly connected.
The following table details the most common problems and how to ix them. If you still have a problem after going
through the troubleshooting guide please call your local YORK distributor for advice.
PROBLEM CORRECTION
NO DISPLAY Check if batteries are inserted correctly, check batteries.
NO PULSE SIGNAL Verify all wires are connected properly
FOR YOUR OWN SAFETY, DO NOT OPEN PROTECTIVE CASING. IF ERROR PERSISTS, PLEASE CONTACT
YOUR LOCAL YORK DISTRIBUTOR FOR ADVICE. KEEP THE EQUIPMENT OUT OF USE UNTIL IT IS REPAIRED.
If you are having problems with your heart rate reading, please note that some ibres used in clothes eg) polyester,
create static electricity that may prevent a reliable heart rate reading. Mobile phones, TV’s, microwaves and other
electrical appliances that generate an electromagnetic ield may also interfere with heart rate measurement.