76-QD0460EN-01Y00-00
19
■
8. Use
Before use, read, especially
「●Operation, Driving」of Chapter 1 「■Safety Care」
carefully and
use the product properly after fully understanding the Manual.
8.1. Operation Mode
Stand alone
Using YZ-TH alone
Stand-by mode
This is the mode before pulling the throttle lever after installing the battery pack
or after 15 minutes from the last pull of the throttle lever.
Cooling fan and LED would be turned off.
Operation mode
When pulling the throttle lever at stand-by condition, it turns into operation
mode and the main shaft rotates, activating the cooling fan. During the
operation mode, LED lamp lights and the buzzer sounds at tightening
judgement. At the occurrence of alarm or error, LED lamp lights or blinks.
After 15 minutes from the last pull of the throttle lever, it goes into a Stand-by
mode.
Operation connecting with setting device
Using YZ-TH connecting with setting device
Setting Mode
When pulling the throttle lever after connecting the setting device and then,
installing the battery pack, setting mode starts. The cooling fan and LED lamp
do not activate. This mode can set tightening parameter, check the rundown
results, and run into test mode.
*Note: The tool does not run even when pulling the throttle lever at the setting
mode
Test Mode
By selecting the test mode from the setting mode, test mode starts.
At test mode, the main shaft rotates when pulling the throttle lever and
tightening can be possible. The tightening results display on the setting device.
