● Initial setting value of the transmitter: (After setting the transmitter as follows, perform the initial setup of the
amplifier)
Throttle Level
100％
Brake Level
100％
Throttle EXP
0%
Throttle Neutral Trim
0
Throttle Servo Reverse
Reverse (Futaba,KO, Sanwa)
● ESC settings are available to change regarding on use of each categories.
*An optional program box is required to change each setting.
● Connect attached wire to the program box.
● Connect program box to the program port of the ESC main unit.
● Connect ESC and battery. When ESC is turned on, program box will start automatically. Loading… is displayed
on the screen and ESC setting program box will be read. When reading the programming is completed,
"YOKOMO" and "Program" are displayed on the screen, and ESC setting will be able to change, and programming
can be changed easily.
● A-B-C wires connected to the motor can be changed to C-B-A by changing the initial settings of the
programming card.
■ Common to R160 and R100
Connect the charged battery to the ESC. (Be careful on polarity)
For safety, avoid tires to touch the ground to prevent the car from moving.
① Turn on the transmitter.
② Hold the throttle trigger of transmitter at full brake side.
③ Turn on the power while holding the throttle on brake side.
(Since R100 does not have a power switch, battery connector becomes as power switch.)
④ Red LED blinks twice to enter the setup.
⑤ After red LED blinked twice, if throttle trigger is held to full throttle, red LED will blink twice.
⑥ Return the throttle trigger to neutral position and when red LED lights up, the setting is completed.
** If the initial setting cannot be made, change the throttle of the transmitter from the reverse setting to the normal
setting, and then set the amplifier again.
** Some transmitter manufacturers have a high response mode setting. Depending on the transmitter manufacturer,
the initial setting may not be possible, so set the ESC with the normal mode of the transmitter.
■ Default Settings
■ Changing ESC Settings
