9 - 16
IM 4H3B1-01E
9.4 How to Change Initial Settings for Digital Printouts
This paragraph describes how to change initial settings for digital printouts.
(Note that the selection to trigger the recording to start/stop is explained in 9.9)
9.4.1 How to select channel numbers or tag printout (initial value = ‘
CH
’)
9.4.2 How to select scales printout ON/OFF (initial value = ‘
ON
’)
9.4.3 How to select the new chart speed printout ON/OFF (initial value = ‘
OFF
’)
9.4.4 How to select the record start time printout ON/OFF (initial value = ‘
OFF
’)
9.4.5 How to select alarm settings and alarm printout (initial value = ‘
ON1
’)
9.4.6 How to select to trigger the periodic printout (initial value = ‘
INT
’, ‘
AUTO
’)
9.4.1 How to Select Channel Numbers or Tag Printout
You can select channel numbers or tags printed out in the periodic, manual, channel and
alarm printout. This also results in displaying tags or channel numbers on the display.
The initial value is ‘
CH
’, and this setting is common for all channels.
SETTING PROCEDURE:
Enter the SET UP Mode by turning ‘
ON
’ the power while pressing and holding the
ENT
-key until the SET UP display appears.
Use the
UP/DOWN
-keys to select the display ‘
SETUP=RCD
’. Press the
ENT
-key.
Press the
ENT
-key until the display ‘
CH/TAG=...
’ will appear. Select CH or TAG.
Press the
ENT
-key.
This setting has been completed, but has not been stored yet. Before you can adjust
other settings in the SET UP Mode, you have to finish the recording settings until the
‘*
RCD SET
*’ display appears.
Before leaving the SET UP Mode, you have to store your new settings. Proceed with the
recording settings until the display ‘*
RCD SET
*’ appears. Press the
ESC
-key to return
to the ‘
SETUP=RCD
’ display and then select the ‘
SETUP=END
’ display.
Press the
ENT
-key. Select ‘
END=STORE
’ to keep your new settings or
‘
END=ABORT
’ and press the
ENT
-key. After a few seconds, the Operation Mode will
appear.
9.4.2 How to Select Scales Printout ON/OFF
You can select to get scales printed on the chart.
Note that the scales will not be printed when the chart speed exceeds 1500 mm/h. (pen
model) or 100 mm/h. (dot model).
The initial value is ‘
ON
’.
SETTING PROCEDURE:
Enter the SET UP Mode by turning ‘
ON
’ the power while pressing and holding the
ENT
-key until the SET UP display appears.
Use the
UP/DOWN
-keys to select the display ‘
SETUP=RCD
’. Press the
ENT
-key.
Press the
ENT
-key until the display ‘
SCL_PR=...
’ will appear. Select ON or OFF.
Press the
ENT
-key.
This setting has been completed, but has not been stored yet. Before you can adjust
other settings in the SET UP Mode, you have to finish the recording settings until the
‘*
RCD SET
*’ display appears.
Before leaving the SET UP Mode, you have to store your new settings. Proceed with the
recording settings until the display ‘*
RCD SET
*’ appears. Press the
ESC
-key to return
to the ‘
SETUP=RCD
’ display and then select the ‘
SETUP=END
’ display.
Press the
ENT
-key. Select ‘
END=STORE
’ to keep your new settings or
‘
END=ABORT
’ and press the
ENT
-key. After a few seconds, the Operation Mode will
appear.
