6
IM 04L51B11-01EN
Le présent émetteur radio IC Number 8999A-WIC001 a
été approuvé par Industrie Canada pour fonctionner avec
les types d’antenne énumérés ci-dessous et ayant un gain
admissible maximal et l’impédance requise pour chaque
type d’antenne. Les types d’antenne non inclus dans
cette liste, ou dont le gain est supérieur au gain maximal
indiqué, sont strictement interdits pour l’exploitation de
l’émetteur.
Antenne type: Gain:
COLLINEAR 9dBi, 50Ω
Sleeve 2.14dBi, 50Ω
RF Exposure Compliance:
This equipment complies with IC radiation exposure
limits set forth for an uncontrolled environment and
meets RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment has very low levels
of RF energy that it deemed to comply without
maximum permissive exposure evaluation (MPE). But
it is desirable that it should be installed and operated
keeping the radiator at least 20cm or more away from
person’s body (excluding extremities: hands, wrists,
feet and ankles).
Cet équipement est conforme aux limites d’exposition
aux rayonnements énoncées pour un environnement
non contrôlé et respecte les règles d’exposition aux
fréquences radioélectriques (RF) CNR-102 de l’IC. Cet
équipement émet une énergie RF très faible qui est
considérée conforme sans évaluation de l’exposition
maximale autorisée. Cependant, cet équipement doit
être installé et utilisé en gardant une distance de 20
cm ou plus entre le dispositive rayonnant et le corps (à
l’exception des extrémités : mains, poignets, pieds et
chevilles).
• Wireless module is compliant with ISA100 Wireless
(IEEE802.15.4)
1 Installation category (overvoltage category) II:
Describes a number which defines a transient
overvoltage condition.
Implies the regulation for impulse withstand voltage.
“II” applies to electrical equipment which is supplied
from the fixed installation like a distribution board.
2 Pollution degree 2:
Describes the degree to which a solid, liquid, or
gas which deteriorates dielectric strength or surface
resistivity is adhering.
“2” applies to normal indoor atmosphere.
Normally, only non-conductive pollution occurs.
3 Measurement category: Depends on the specification
of each modules
Category Measurement
category
Description
Remarks
II
CAT II
Available in the testing
and measuring circuits
directly connected
to a usage location
(receptacle or the like)
of a low-voltage main
power supply facility.
Appliances,
portable
equipment,
etc.
III
CAT III
Available in the testing
and measuring circuits
connected to a power
distribution portion of
a low-voltage main
power supply facility.
Distribution
board,
circuit
breaker,
etc.
IV
CAT IV
Available in the testing
and measuring circuits
connected to a power
source of a lowvoltage
main power supply
facility.
verhead
wire, cable
systems,
etc.
Radio Wave
•
The operating frequency bandwidth of
this transmitter may overlap the same
range as industrial devices, scientific
devices, medical devices, microwave
ovens, licensed premises radio sta-
tions and non-licensed specified low-
power radio stations for mobile object
identification systems used in factory
production lines.
•
Before using this transmitter, ensure
that neither a premises radio station
nor specified low power radio station
for mobile object identification sys
-
tems is in use nearby.
•
If this transmitter causes radio wave
interference to a wireless station for
mobile object identification systems,
promptly change the frequency being
used or turn off the source of radio
wave emissions.
Then, contact a Yokogawa office regard
-
ing countermeasures to prevent inter-
ference, such as setting up partitions.
