IM 701240-02E
Changing the Voltage Range of CH1 and CH2 to 5.00 V
Section 5.19, "Entering Settings on the All Channel Menu" in the user's manual
Use the all channel menu* to set the voltage range of CH1 and CH2. Here, we change the voltage range so that the entire
sine wave with an amplitude of approximately 5 V is displayed and recorded as large as possible.
* A menu that is convenient for setting all channels and checking the settings.
1
Press
ALL CH
.
6
Likewise, set CH2.
2
Turn the
jog shuttle
to move the cursor to
500V at row CH1 and column Range.
You can use the arrow keys under the
jog shuttle to move the cursor horizontally.
The cursor position is highlighted.
3
Press .
The voltage range selection menu appears.
4
Turn the
jog shuttle
to move the cursor to 5V.
5
Press key to confirm.
Voltage range setting Top section:
Voltage range before the change (voltage range that can be changed
before the voltage range is changed*)
Bottom section:
New voltage (voltage range that can be displayed when the waveform
acquisition is started)
* Up to this point, the steps were carried out without the waveform acquisition in progress. Because the
acquisition is not in progress, the voltage range for acquiring waveforms is not updated even if the
voltage range setting is changed.
The voltage range before the change is displayed at the top section as Span, and the new voltage
range is displayed in the bottom section as Range.
Note
You can also change the voltage range (measurement range) of each channel by pressing , selecting the desired channel
on the channel selection menu, and turning the RANGE knob.
CH
SELECT
SELECT
ALL CH
Recording X-Y (Amplitude-Amplitude) Waveforms