<1. INTRODUCTION>
1-3
IM 01R01B02-00E-E 12th edition October 01, 2014 -00
All Rights Reserved. Copyright © 2003, Rota Yokogawa
1.2 Warranty
• The warranty of this instrument shall cover the
period noted on the quotation presented to the
Purchaser at the time of purchase. The Seller
shall repair the instrument free of charge when
the failure occurred during the warranty period.
• All inquiries on instrument failure should be
directed to the Seller’s sales representative from
whom you purchased the instrument or your
nearest sales office of the Seller.
• Should the instrument fail, contact the Seller
specifying the model and instrument number of
the product in question. Be specific in describing
details on the failure and the process in which
the failure occurred. It will be helpful if
schematic diagrams and/or records of data are
attached to the failed instrument.
• Whether or not the failed instrument should be
repaired free of charge shall be left solely to the
discretion of the Seller as a result of an
inspection by the Seller.
The Purchaser shall not be entitled to
receive repair services from the Seller free
of charge, even during the warranty period,
if the malfunction or damage is due to:
• improper and/or inadequate maintenance of the
instrument in question by the Purchaser.
• handling, use or storage of the instrument in
question beyond the design and/or specifications
requirements.
• use of the instrument in question in a location
not conforming to the conditions specified in the
Seller’s General Specification or Instruction
Manual.
• retrofitting and/or repair by an other party than
the Seller or a party to whom the Seller has
entrusted repair services.
• improper relocation of the instrument in question
after delivery.
• reason of force measure such as fires,
earthquakes, storms/ floods, thunder/lightning, or
other reasons not attributable to the instrument
in question.
1.3 Notices regarding EMC
The Rotameter
RAMC
is conform to the European
EMC Guideline and fulfills the following standards:
- EN 61326-1- EN 55011The
RAMC
is a class A
product and should be used and installed properly
according to the EMC Class A requirements
Alt-
hough the transmitter has been designed toresist
high frequency electrical noise, if a radiotranscei-
ver is used near the transmitter or itexternal wiring,
the transmitter may be affected byhigh frequency
noise pickup. To test for sucheffects, bring the tran
-
sceiver in use slowly from adistance of several me-
ters from the transmitter,and observe the measure-
ment loop for noiseeffects. Thereafter, always use
the transceiver outside the area affected by noise.
Summary of Contents for RAMC
Page 2: ...Blank Page ...
